11
Note:
You must not hinder or assist the drive as it
automatically draws in the CD.
쏅 Insert the CD with its printed side up into the
CD tray
5
until you feel a slight resistance.
The drive automatically draws in the CD and
checks its data. Afterwards, the playback
starts in CD or MP3 mode.
Note:
If the inserted CD cannot be played back, "CD
ERROR" is brie y displayed and the CD is au-
tomatically ejected after approx. 2 seconds.
Ejecting a CD
Note:
You must not hinder or assist the drive as it
ejects the CD.
쏅 Press the
button
8
to eject an inserted
CD.
Notes:
• If a CD is ejected and not removed, the
drive will automatically draw it back in
again after approx. 10 seconds.
• You can also eject CDs while the car sound
system is switched o or whilst another au-
dio source is activated.
Connecting/removing a USB data
carrier
Connecting a USB data carrier
쏅 Switch o the car sound system so that the
data carrier will be correctly registered.
쏅 Pull the protective cap of the USB socket
9
to the front until it moves out of the socket
and fold it down.
쏅 Connect the USB data carrier.
쏅 Turn on the car sound system.
If the USB data carrier is initially selected as
audio source, the data are read rst.
Notes:
• If the connected USB data carrier cannot
be seen, "USB ERROR" is brie y displayed.
• The time required for reading in the data
depends on the design and size of the USB
data carrier.
Removing a USB data carrier
쏅 Switch o the car sound system so that the
data carrier will be correctly unregistered.
쏅 Disconnect the USB data carrier.
쏅 Close the protective cap of the USB socket
9
.
Inserting/removing the memory card
(Adelaide 130 only)
Inserting the memory card
쏅 Detach the control panel.
쏅 Insert the memory card with its labelled side
up and its contacts rst into the card slot
?
until it clicks into place.
쏅 Attach the control panel.
After switch-on, the device automatically
selects the inserted memory card as audio
source. The data of the memory card are be-
ing read. Afterwards, the playback starts in
MP3 mode.
Notes:
• If the inserted memory card cannot be
played, "SD ERROR" is brie y displayed.
• The time required for reading the card
depends on the design and size of the
memory card.
Removing the memory card
쏅 Detach the control panel.
쏅 Push on the memory card until it disengages.
쏅 Pull the memory card out of the card slot
?
.
쏅 Attach the control panel.
Selecting tracks
쏅 Press the / button
7
brie y to change
to the previous/next track.
Note:
If the current track plays longer than 3 sec-
onds, pressing
7
once restarts the track.
CD/MP3/WMA mode
To Next Page
Loading...
