Blaupunkt BLUEBOT XPRO - Page 32

32
E. Take out the HEPA lter and the primary lter. It is not recommended to
clean the HEPA lter with water. Tap gently to remove the dust.
F. Rinse the primary lter
G. The dust container can be cleaned with a soft cloth, brush or i.e. the
mop pad. Please pay attention: It is not recommended to wash the dust
container with water.
H. Let the wet parts of the dust container fully dry before inserting it again
to the Robot to ensure its service life and do NOT dry the primary and HEPA
lter in bright sunlight.
Remark!: it is recommended to wash the primary lter with water (after 15
– 30 days) and to replace the HEPA lter each 3 months.
I. Insert the Primary lter and the HEPA lter into the dust container
J. Close the dust container cover and install the dust container in the
Robot.
Note: Do not wash the dust container with water.