Filter cover
Dustbin button
Wall sensor
LDS laser ranging sensor
Anti-collision sensor for radar
Anti-collision sensor
Infrared recharging sensor
PRODUCT INTRODUCTION
Dustbin
Clean it regularly
Maintenance dustbin
1. Press the button and pull the dustbin out backwards.
2. Open, empty and clean the dustbin.
Maintenance lter
3. Remove the filter gauze, sponge, and HEPA.
4. Clean the removed filter gauze, sponge, and HEPA with
water if needed.
5. Shake off the water drops and dry the pieces naturally,
only use them after they have completely dried.
6. When dry, install them in the following sequence:
filter gauze - sponge -HEPA.
Filter gauze
Button
Filter cover
Sponge
HEPA