F. Playback and Delete
In video Standby mode, long press DOWN/MODE key twice to enter into playback mode.
Short press UP/MENU and DOWN/MODE key to select the file and then press OK/REC
key to start or pause playback. Long press OK/REC key to switch among DCIMA, DCIMB and
LOCKFILE folders to view videos and photos. If you want to delete a file, long press UP/MENU
key to enter into the menu. Select from File delete, Protect and Slideshow options. Long press
UP/MENU key to go back to previous menu.
Note:
Please Long press DOWN/MODE key to exit Playback mode first and then long press Power
key if you want to switch off DVR while In Playback mode. Protect will lock/unlock a file
manually. Once the file Is locked, It won't be overwritten In loop recording and can only be
deleted manually.
G. Switching between Front and In-cabin Lens
In video and photo standby mode, short press UP/MENU key to switch between front and in-
cabin lens. Available options are Front lens full screen display, in-cabin lens full screen display,
picture-in-picture and half & half display.
H. G-Sensor
In case of emergency braking or a collision, the G-sensor will be activated to save and protect
the current video clip from being overwritten automatically and will be shown with a key
and G-sensor icon that appears at the top middle of the screen. Three setting options are
available (High, Medium & Low). Medium is recommended.
I. Motion Detection
In video standby mode, long press UP/MENU key to go to the video menu and turn on motion
detection. When DVR detects a moving object, it starts to record automatically. If there is no
movement in front of the front lens for 20 seconds, DVR will stop recording automatically and
go into Standby mode until movement is detected.
When motion detection ON is selected, the icon is displayed on the screen. Short press OK
/ REC key while in recording mode to turn OFF motion detection.
J. Parking Monitoring
Parking monitor is for security monitoring while the vehicle is parked.
Once Parking Monitoring ON is selected in the video menu the screen will display the icon .
Once the vehicle ignition is turned OFF, the DVR will power OFF. In case the DVR detects any
vibration, it will power ON to record for 30 seconds automatically with a key icon displayed at
the top middle of the screen and then power OFF. If there is continuous vibration, DVR will turn
on again to record for 30 seconds until the built-in battery is drained completely. All videos
created in Parking Monitoring mode without external power supply will be available in the
BP 4.0 - FHD
To Next Page
Loading...