1. Cordless drill
2. Battery pack
3. Release button
1
3
2
Initial operation
• Insert battery pack into the bottom of the handle ( until click )
• Remove the battery pack by pressing the release buttons on the battery pack at the same time
and by pulling the battery pack out.
Battery charging
a) Only use the included charger for charging the batteries.
b) Do not touch the charger contacts.
c) The power tool/charger/battery should always be dry and never exposed to atmospheric precipitation.
d) Never charge the battery while outside.
e) The power tool/charger/battery should always be stored in a room where the temperature is no higher than 40°C
and no lower than 0°C.
f) Due to the risk of explosion, the battery must never be heated.
g) If the battery cells get damaged, the battery must be replaced.
h) In case skin comes into contact with the electrolyte, wash the exposed spot with soap and water, then rinse with
lemon juice or vinegar.
i) If the electrolyte gets into the eyes, immediately and thoroughly ush them with water for 10 minutes and seek
medical advice at once.
j) Protect the battery contacts from touching any metal parts, as this poses the danger of stray currents.
k) Do not try to use the charger if it is damaged.
I) Do not use the charger if you notice that the power cord or the plug are damaged.
m) Immediately replace a battery if it is damaged. Damaged batteries must not be used.
n) Never dismantle the charger or battery housing.
Caution
• Fully charge battery before rst use. The battery will reach full capacity after being charged and discharged
several times
• Avoid short periods of charging. Only charge battery pack when fully empty.
• Adaptor, charger and battery pack will be warm when charging. This is normal.
7
To Next Page