Blaupunkt CR67 - Radio Operation; Bass, Treble, Balance, and Fade; Loudness Control; Band and Preset Management

AUDIO TS
Bass, Treble, Balance and Fade
Press Mute/AUDIO for more than l/2 second to access Bass. Subsequent presses access Treble,
Balance and Fade modes.
Bass -Adjust from +7 to -7 at 2 dB/step using + to increase bass, - to decrease.
Treble - Adjust from +7 to -7 at 2 dB/step using + to increase treble,- to decrease.
Balance - Adjust balance from 9 (all the way left) using + to -9 (all the way right) using -.
Fader - Adjust fader from 9 (sound only from the front) using + to -9 (sound only from the rear) using -.
Loudness (LD)
Press LD to increase sound of low and high frequencies. LOUD icon appears. To cancel, press LD
again.
Radio Operation
Last Station Memory
Each FM bank and AM band has its own last station memory which holds last-tuned frequency for
that band or bank irrespective of whether that frequency is stored into a preset.
Selecting Bands ’
Press SRC as needed to access FMl, FM2, FM3/FMT, AM/AMT banks.
Seek Tuning
Press A or V to seek next receivable frequency. Tuning stops at frequency that fulfills sensitivity
requirements predetermined by sensitivity set through SENS/LD button.
Tuning Sensitivity (SENS)
Press SENS/LD for more that 2seconds to switch between local (lo) and distant search sensitivity.
Radio Reception Hints
l When listening to weak or distant AM stations, adjusting the Treble to minimum (-7) will reduce
noise and improve sound.
l In general, set SENS to in the distant mode ( so that “lo” does not appear) if in rural areas or
where stations tend to be weak and distant, and to lo when in metropolitan areas or where
stations tend to be strong and local.
Stereo Symbol
Stereo symbol turns on if a stereo station with an incoming signal of at least 20 dBpV is received.
The unit gradually switches between mono to stereo automatically.
Manual Tuning
Press A or V for more than l/2 second and frequency will go one channel/step in direction pressed.
Press and hold causes continuous manual tuning. Unit returns to seek tuning mode after 4 seconds
or after storing a station on a preset.
14