CRP10BK
ENGLISH
time during set-up, the clock will exit the alarm set-up mode.
TO TURN ON OR OFF ALARM 1 AND 2
1. Press AL 1.2/ON.OFF once to activate Alarm 1, appears.
2. Press once again to activate Alarm 2, appears.
3. Press once again to activate both Alarm 1 and 2. Both and appear.
4. Press once again to deactivate both alarms (both and disappear).
TO STOP AND RESET THE ALARM TO COME ON THE NEXT DAY
When alarm 1 or 2 is sounding, the related alarm icon flashes. Press the RADIO/SLEEP or AL
1.2/ON.OFF once to stop the alarm and reset it to come on the following day. After that both
and/or remain on the display.
SNOOZE OPERATION (default snooze duration is 5 minutes)
When alarm is sounding, presses once, the alarm will be silenced and come on again
after the set snooze duration.
Note: if your second alarm activates while the first alarm is sounding or it is in the snooze
mode, the second alarm overrides the first alarm (the first alarm is reset to come on the next
day).
USING THE HI-LO DIMMER
Press to adjust the brightness (HI/ LO/OFF) of the LCD backlight. This can only be
done when the radio is off or the unit is not sounding.
SETTING UP THE FM ANTENNA
Extend the FM wire antenna fully and vary the direction for best FM reception. Do not strip,
alter or attach to other antennas.
LISTENING TO THE FM RADIO
1. To turn on the radio, press RADIO/SLEEP once, the display shows “ON” and then the radio
frequency readings in Mhz.
2. Press / to tune the radio to a desired station. Press and hold / to scan for
the next clear station.
3. To adjust the volume, press VOL once, the display shows “L07”, press / to adjust
volume from L00 (minimum) to L15 (maximum)
4. Press to turn off the radio.
Remark: keep your radio away from fluorescent lamps or other electronic devices, which may
cause interference to the radio.
USING THE PRESET MEMORY
This clock radio features a total of 10 preset memories of FM stations. These allow you to preset
your favorite stations and access them quickly.
7
To Next Page
Loading...
