32
Note:
It is necessary to activate/deactivate
REG in the menu.
Switching REG on/off
➮ Press MENU 8.
➮ Press : repeatedly until “REG”
appears in the display. “OFF” or
“ON” will appear next to “REG”.
➮ Press or : to switch REG off
or on.
➮ Press MENU 8 or OK ;.
Switching RDS functions on/off
➮ To take advantage of the RDS
functions for AF and REG, press
RDS 4.
When the RDS functions have been
activated, “RDS” will light up as a sym-
bol in the display. When you activate the
functions, “REG ON” or “REG OFF” will
appear briefly in the display.
Selecting wavebands/memory
banks
Using this car audio system, you can
tune into radio stations on the FM, MW
and LW (AM) wavebands. There are
three memory banks for the FM wave-
band and one memory bank each for
MW and LW (the Sylt CD50 does not
include MW/LW radio).
You can store six stations in each of
these memory banks.
➮ To switch between the different FM
memory banks or wavebands,
press BND / TS 5.
Tuning into radio stations
You can tune into radio stations in a
number of different ways.
Automatic seek tuning
➮ Press or :.
The radio will tune into the next availa-
ble station within reception range.
Manual station selection
You can also tune into radio stations
manually.
➮ Press or :.
Note:
You cannot use manual tuning unless
the RDS functions are deactivated.
Paging through the broadcasting
network (for FM only)
If a radio broadcasting network has
more than one station, you can page
through the “station network”.
➮ Press or : to tune into the
next station in the network.
Note:
To take advantage of this function, you
must have activated the RDS functions.
It is only possible to tune into those sta-
tions which have been received once
before already. To do this, use the SCAN
or TravelStore function.
RADIO OPERATION
To Next Page
Loading...
