EasyManua.ls Logo

Blaupunkt ESC808 - Charging and First Run; Battery Charging Procedures; First Run Preparation and Start

Blaupunkt ESC808
144 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8
Charging
port
Battery
interface
Charging the battery
• Make sure that the electrical outlet is dry.
To (re)charge the battery when it is installed in the scooter, lift the charger-port cap on the
handlebar, just above the scooter-folding device.
To (re)charge a removed battery, lift the charger-port cap at the bottom of the battery.
• Plug the adapter plug into the power source (110 V ~ 240 V, 50 Hz ~ 60 Hz), make sure the green
charging lamp is lit, insert the other adapter plug into the scooter’s charging socket.
When the red LED on the power supply lights up, the battery is charging correctly, otherwise check
all cable connections.
When the red light turns green, the battery is fully charged. Disconnect the power supply from the
power source. Long-lasting charging can shorten battery life.
• Follow the instructions for charging the battery, otherwise it will damage the battery and shorten
its service life.
The time to charge the scooters battery is about 2 hours. The manufacturer cannot guarantee the
same charging time and operation of the battery due to its wear.
• Ensure clean and dry conditions when charging the battery.
• Do not charge the battery when the power outlet is wet.
First run
Preparation
• Select the desired location. This place can be inside or outside, it must have an area of 10 x 10 meters
(about 100 square meters). The place should be flat, neither wet nor slippery, without obstacles,
without vehicles, children, pets or any other things that could distract your attention.
• Read this manual carefully, if you have the opportunity to do so, for advice from a person who is
more experienced in safe driving.
Wear helmet and protectors to avoid possible injuries. Move the scooter to the center of the area
where you will be moving and familiarize yourself with the area.
Start
• Press and hold the POWER push button for 2 seconds to switch the scooter on, then select one of the
three speed modes
• Place one foot on the deck plate and with the other foot kick-start the scooter
• Place the other leg on the deck plate and ensure you keep your balance
• Press the thumb throttle with your right thumb, and do not ride too fast
• Squeeze the brake lever with your left hand to brake, and gently press the rear fender to assist the
braking
You can get off the scooter when it is running at a low speed or after it has come to a complete stop
To warn other users that you are nearby, use the bell fitted next to the brake lever
ESC808

Related product manuals