Need help?Do you have a question about the Blaupunkt GTA 2 SPEZIAL and is the answer not in the manual?
Details fuse placement, battery disconnection, vehicle safety, mounting, drilling, and location suitability for installation.
Emphasizes proper installation for performance, recommending professional installation or careful DIY.
Details maximum and RMS power output for Stereo and Mono modes at different impedances.
Lists key technical specifications including signal-to-noise ratio, distortion, input sensitivity, and dimensions.
Explains proper positive and negative cable connection to the battery and ground points.
Describes the role of internal fuses in protecting the amplifier and electrical system.
References diagrams for power supply, radio connection, and loudspeaker connections.
Explains connecting the remote terminal to a switchable +12V source for power control.
Details how to adjust input sensitivity to match the car radio's output voltage.
Provides guidance on connecting speakers with correct polarity for stereo and bridged modes.
Explains mono configuration for subwoofers or mid-range speakers, summing channels.
Describes selecting crossover type (low-pass/high-pass) and frequency for speaker response.
Illustrates a typical mounting arrangement for the amplifier.
Shows the connection of +12V, Ground, and Remote terminals to the vehicle's power supply.
Details Line Out, Input Level, X-OVER (Low/High Pass), and Bass Boost controls.
Illustrates connecting two speakers in stereo mode with minimum 2 Ohm impedance each.
Shows connecting two sets of speakers, each with a minimum 2 Ohm impedance.
Illustrates connecting a single speaker in bridged mode with minimum 4 Ohm impedance.
Provides phone and fax numbers for Blaupunkt service in various countries.
To Next Page
General