Blaupunkt HAMBURG MP57 - Page 48

User settings
case, the volume listened to is used
for mute.
• if the volume currently listened to is
higher than the set TEL volume. In
this case, phone calls/navigation an-
nouncements are reproduced with
the volume listened to.
Activating/deactivating the signal tone
(BEEP ON/OFF)
You can deactivate the signal tone that
sounds as a confirmation in the menus or
when storing the stations on the station but-
tons .
....
In the Volume menu, press the rocker
switch /\ or v @ repeatedly until
"BEEP ON/OFF" is displayed .
....
Switch between the settings with the
rocker switch < or > @.
• < "BEEP OFF" signal tone off
• >
"BEEP ON" signal tone on
Setting the speed-dependent volume
increase (AUTO SOUND)
When you are driving faster, the device can
automatically increase the volume to com-
pensate for the driving noise. The volume is
increased depending upon the speed. In or-
der for this to work, the speedometer signal
must be connected as described in the in-
stallation instructions.
The optimum setting for this volume in-
crease depends on how noise levels devel-
op in your particular vehicle. Try the setting
that is perfect for your vehicle. You can se-
lect a value between 0 (no increase) and
max. 5.
48
.... In the Volume menu, press the rocker
switch 7\ or v @ repeatedly until
"AUTO SOUND" is displayed.
.... Press the rocker switch> @ to display
the setti ng.
.... Set the desired value with the rocker
switch /\ or v @.