Adjusting the volume
The volume can be adjusted using the left button/knob from 0 (no
sound) to 50 (full volume).
The unit displays the volume level set for a few seconds afterwards.
Depending on the setting, the car radio saves the last volume or the
preset volume when it is turned on again (see section SETTINGS | MENU).
Setting the playback volume:
During music playback, turn the control dial to set the volume.
Setting the volume of traffic announcements (traffic announcement
prioritisation must be switched on in the settings, see section SETTINGS |
MENU):
During a traffic announcement, turn the button/knob to change the
volume; this value is automatically stored and can be changed in the
settings (see section SETTINGS | MENU).
Setting the Bluetooth® (telephone) volume:
During a phone call, turn the button/regulator to change the volume.
This value is stored automatically and can be changed in the settings (see
section SETTINGS | MENU).
In addition to that, you can, if needed, adjust the volume of the call and
ringtone on the cell phone – refer to the phone manufacturer's manual.
You can also adjust the microphone sensitivity, see section SETTINGS |
MENU
Muting your car radio (Mute)
Briefly press the Power On/Off button to mute the unit or unmute with
the volume setting last used. The car radio displays MUTE. Media
playback is paused and resumes when the mute function is cancelled
again.
Always listen to the unit at a moderate volume to protect your
hearing and be able to hear sound warning signals (like police
horns).
When Mute is enabled (e.g. when toggling through the sound sources),
no change in volume adjustment can be heard. Do not increase the
volume with Mute enabled.
.
To Next Page
Loading...
