52
Training the new KeyCard
• Insert the new KeyCard into the unit
and lock the operating panel into posi-
tion.
• Press ON.
• Within the next 5 seconds, press TU
and ST1. “0000” will appear in the dis-
play.
• Now use the rocker switch to enter the
four-digit master code in the radio
pass:
/ - Enter digits (press as often
as required)
<< / >> - Select the entry position.
• Press ENT after you have entered the
correct master code.
The new KeyCard has been accepted when
the unit switches to play.
Making mistakes in the entry
If you enter the wrong code, “CODE-ERR”
will appear in the display. If you enter the
wrong code three times, “WAIT 1h” will ap-
pear in the display. The unit will switch to a
standby mode for one hour.
• Switch the unit off and on again.
Repeat the steps to train the new KeyCard,
but be sure to enter the correct master code.
KeyCard theft protection system
Care of your KeyCard
To ensure that the KeyCard will function
properly it is important that the contacts are
free from any foreign particles. Avoid direct
skin contact.
If necessary, clean the KeyCard contacts
using a cotton swab soaked in rubbing al-
cohol.
Lost or damaged KeyCard
If the KeyCard for your unit is lost or dam-
aged you can train a new KeyCard.
You can purchase the new KeyCard from
any authorised dealer. You will also require
the master code for the unit, which you will
find in the radio pass.
Always keep the radio pass in a safe
place. Do not leave it in your vehicle.
Alab/Seatt/Tokyo gb 95%® 08.05.2002, 10:34 Uhr52
To Next Page
Loading...
Need help?
General
