ENGLISH
E-12
Specifications
GENERAL
Dimensions : Approx. 178 mm × 50 mm × 155 mm
(W × H × D)
Power requirements : 12 volts DC car battery
(negative ground)
Output Power : 23 watts RMS × 4 ch/40 watts peak × 4 ch
Output Wiring : Floating-ground type designed for 4
speaker use.
Output Impedance : Compatible with 4-8 ohm speakers.
TUNER
Tuning Range : AM : 530 - 1,710 kHz (10 kHz step)
FM : 87.5 - 107.9 MHz (200 kHz step)
Sensitivity : AM : 20 µV
FM : 9.1 dBf mono sensitivity
FM
Stereo Separation : 35 dB
CD PLAYER
Frequency
Response : 20 - 20,000 Hz
S/N Ratio : 98 dB
Wow & Flutter : Below the measurable limit
OTHER
Remote Control options : RC-823 Credit Card Remote
Troubleshooting Guide
The following check will assist in the correction of most prob-
lems which you may encounter with your unit. Before going
through the check list below, refer back to the connection and
operating procedures.
General
Radio reception
Also make sure that antenna is connected, extended and dry
inside.
If the above mentioned solutions do not help to improve the
situation, consult your nearest Blaupunkt dealer or in the
United States call 1-800-266-2528 for technical assistance,
parts and service. Call 1-800-950-2528 for dealer referral or
to request product brochure.
Cause/Solution
Leads are not matched
correctly with the car’s
accessory power
connector.
Check wiring for short
circuits.
The car doesn't have an
ACC position.
Trouble
• Memorized stations and
correct time are erased.
• The fuse has blown.
• Radio works when the igni-
tion key is the ON, ACC and
OFF positions.
• No power is being supplied
to the unit.
• The power is continuously
supplied to the unit.
Trouble
Preset stations are not re-
ceivable.
Seek tuning is not possible
Travel Store feature does
not complete storing of six
stations.
Cause/Solution
The broadcast signal is too
weak.
The broadcast signal is too
weak. → Use manual tuning.
Not enough broadcast frequen-
cies are receivable.
CD Player Troubleshooting
When problems occur with CD playback, an error message
appears in the display window.
Refer to the table below to identify the problem, then take the
suggested corrective action. Furthermore, refer to “Returning
to the Initial Settings” on the previous page and reset the
unit. If the error persists, contact your nearest Blaupunkt
dealer.
Dirty disc.
Scratched disc.
Up-side-down.
Data and focus error.
Mechanism probrem.
The disc can not read
propery.
Plays the data track of
MIX mode CD or CD-
ROM.
Clean the disc.
Replace the disc.
Check the disc.
Eject and re-insert.
Eject and re-insert.
Eject and re-insert.
Insert another disc.
You can not play CD-
ROM. Skip the music
track with
/ .
Message Possible cause Recommended action
FOCUS ERR
SERVO ERR
MECHA ERR
TOC ERR
DATA TRK
INDIANAPOLISbody-01Eng 03.11.21, 1:48 PM12
To Next Page
Loading...
