Blaupunkt Kiel CD32 User Manual

33
DANSK
ENGLISH
DEUTSCH
FRANÇAIS
ITALIANO
NEDERLANDS
SVENSKA
ESPAÑOL
PORTUGUÊS
Switching REG on/off
➮ Press the MENU button 7.
➮ Keep pressing the or button
5 until “REG” appears in the dis-
play.
“OFF” or “ON” is displayed alongside
“REG”.
To switch REG on/off,
➮ press the or button 5.
➮ Press the MENU button 7.
Switching the RDS function on/off
To use the RDS functions (AF and
REG),
➮ press the TRAF•RDS button ; for
longer than two seconds.
The RDS functions are active when
RDS lights up in the display.
Selecting the waveband /
memory bank
This unit can receive programmes
broadcast over the FM, MW and LW
wavebands.
Note:
● The MW and LW wavebands are
not available on the Kiel CD32.
There are three memory banks for the
FM range and one for each of the MW
and LW wavebands.
Six stations can be stored in each mem-
ory bank.
Selecting the memory bank
To switch between the FM memory
banks and the MW and LW wavebands,
➮ keep pressing the BND•TS button
< until the required waveband /
memory bank is displayed.
Tuning into a station
There are various ways of tuning into a
station.
Automatic seek tuning
➮ Press the or button 9.
The unit tunes into the next receivable
station.
Setting the sensitivity station
seek tuning
You can configure the radio to only tune
into stations with a strong reception or
to also tune into those with a weak re-
ception.
➮ Press the MENU button 7.
➮ Keep pressing the or button
5 until “SENS” appears in the dis-
play.
➮ Press the button 5.
The display shows the currently set val-
ue for sensitivity. “SENS HI6” means
that the tuner is highly sensitive. “SENS
LO1” means it is set to the lowest sen-
sitivity setting.
If “SENS LO” is selected, “lo” lights up
in the display.
➮ Set the required sensitivity using
the
and buttons 5.
➮ Press the MENU button 7.
RADIO MODE

Blaupunkt Kiel CD32 Specifications

General

Brand	Blaupunkt
Model	Kiel CD32
Category	Car Stereo System
Language	English