EasyManua.ls Logo

Blaupunkt Madrid RCM 105 - Radio Operation and Basic Controls; Ignition Off and Volume Control; Travelstore and Mute Functions

Blaupunkt Madrid RCM 105
19 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Madrid RCM 105 (Inland)
20
4 TS - Travelstore
To store the six most powerful stations
automatically with Travelstore:
Store: press TS until seek tuning starts
in the display.
Recall: press TS, “T” is indicated in the
display. Then briefly press one of the
presets 1, 2, 3, 4, 5, 6.
5 -dB
Press the -dB button to instantly mute
the audio source. The display will then
show “MUTE”. Return to normal volume
by pressing either the -dB button once
again or the VOL+ button.
When pressing VOL-, the normal volu-
me will be identical to the -dB (muted)
volume.
To program the mute volume, proceed
as follows:
Adjust the desired volume with the
VOL+ / VOL- button. Confirm your ent-
ry by pressing the -dB button for about
2 seconds (beep tone is released).
This volume will then be stored as the
mute volume.
Short description
1 ON
Switching on:
Press ON (the KeyCard has to be in-
serted), the set plays with the pre-adju-
sted volume. You may also change this
setting (see chapter “DSC pro-
gramming - VOL FIX”).
Switching off:
Press ON for approximately 1 second.
If the set was turned on by pressing
ON, the KeyCard can be used for swit-
ching the system on and off (KeyCard =
passive anti-theft protection).
The set may also be turned off via the
vehicle’s ignition (provided that it was
connected correspondingly). After the
ignition was switched off, a double
beep tone reminds you that you should
remove the KeyCard before leaving
your vehicle.
To operate the set when the ignition is
switched off (KeyCard is inserted), pro-
ceed as follows:
Press ON approximately 8 seconds
after the ignition was switched off. The
set will be turned on.
To protect the battery, the system will
automatically shut off after a playing
time of one hour.
2 VOL+ / VOL-
Adjust the desired volume with VOL+ /
VOL-.
Each time the set is switched on, it will
play with the pre-adjusted volume. You
may also change this setting (see chap-
ter “DSC programming - VOL FIX”).
3 FM
To select one of the FM memory banks
I and II.
To change the memory bank:
Press button until the desired level is
indicated in the display.

Related product manuals