NOTE:
1. Make sure the disc is completely stopped before opening the CD door.
2. To ensure good system performance, wait until the unit reads the disc completely before
doing anything else.
3. If the disc is unreadable or if no disc is loaded in the tray, the display will show “NO DISC”.
PLAYING A DISC
1. The playback starts from Track 1 automatically after a compatible disc has been loaded and
read by the unit.
To pause playback, press the PLAY/PAUSE button on unit or remote control. The current
track time will flash on the display.
To resume playback, press the PLAY /PAUSE button on unit or remote control again.
2. To stop playback, press the STOP button on unit or remote control. The display will show the
total number of tracks.
SKIPPING TO A TRACK/TIME POINT
To select a desired track
Press the SKIP UP or SKIP DOWN buttons on unit or remote control to skip to the next or
previous track respectively. Track numbers are shown on the display.
To scan quickly to a point in a track
Press and hold the SKIP UP or SKIP DOWN buttons on unit or remote control to quickly scan
forward or in reverse through a track.
The track time is shown on the display.
To select a song which track number exceeds 10（for MP3 disc only）
To select a song/track which number exceeds 10, press the FOLD+/+10/M+ button each time
to skip forward 10 tracks, then press the SKIP UP to select desired track.
To select a desired folder (for MP3 disc only)
To select a desired folder, press and hold the FOLD+/+10/M+ button each time to skip forward
a folder, then press the SKIP UP to select desired track.
PROGRAMING TRACKS
You can create a custom play list from your disc when playback is stopped. You can program up
to 20 tracks for a CD disc and 99 tracks for an MP3 disc
1. While play is stopped, press the PROG./P-MODE/M. button on unit or remote control . The
display will flash PROG and show “P01 001”.
2. Use the SKIP UP or SKIP DOWN buttons on unit or remote control to select the first track to
be saved to the program list, then press PROG./P-MODE/M. on unit or remote control to save.
The display will now show the next program number (e.g., “P02 012”).
3. Repeat step 2 to save more tracks to the program list until all tracks have been programmed.
4. Press the PLAY/PAUSE button on unit or remote control to start playing the program list from
the beginning. The display will show which track is currently playing.
5. Press the STOP button on unit or remote control to stop program playback.
To clear the program, you may the STOP button on unit or remote control when the disc
stopped and open the CD compartment lid. The program is now erased.
11
MC60BT
To Next Page
Loading...
Need help?
General
