EasyManua.ls Logo

Blaupunkt Melbourne SD27 - Telephone;Navigation Audio Settings; Setting Volume Levels; Radio Mode Tuning; Adjusting The Tuner Region

Blaupunkt Melbourne SD27
34 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
12
Adjusting the volume | Radio mode
You can fi nd out from your Blaupunkt dealer
which navigation systems can be used with
your car sound system.
If a call is answered or a navigation an-
nouncement occurs, the display shows
"TELEPHONE".
Telephone Audio/Navigation
Audio
You can set the volume level at which the tel-
ephone calls or navigation announcements
are mixed in.
Press the M/OK button >.
The display shows "MENU".
Press the
or button 5 repeatedly
until "TEL VOL" appears on the display.
Press the M/OK button > to display the
submenu.
"TEL VOL" and the currently set value are
displayed.
Set the desired volume with the
or
button 5.
When you have fi nished making your chang-
es,
press the M/OK button >.
To exit the menu,
press the ESC button 6 or wait approx.
8 seconds.
Notes:
If the volume listened to is higher
than the set "TEL VOL" value, tel-
ephone calls or navigation announce-
ments are played back at the volume
listened to.
Using the volume control 3, you
can adjust the volume for telephone
calls and navigation announcements
directly during the playback.
You can adjust the volume distribu-
tion for telephone calls and naviga-
tion announcements during the play-
back. For further information, please
read the "Sound" chapter.
Radio mode
Adjusting the tuner
To ensure proper functioning of the tuner,
the device must be set for the region in
which it is being operated. You can select
among Europe (EUROPE), America (USA),
South America (S-AMERICA), and Thailand
(THAI). The tuner is factory-set to the region
in which it was sold. If you experience prob-
lems with your radio reception, please check
this setting.
The radio functions described in these oper-
ating instructions refer to the tuner setting
America (USA).
Switch off the device by pressing button
2.
Hold the buttons 3 = and AUDIO <
pressed at the same time and switch on
the device again with button 2.
The current setting is displayed.
Select your tuner region with the
or
button 5.
To save the setting and to exit the menu,
Press the M•OK button >.
MelbourneSD27.indb 12 1/31/07 2:10:04 PM

Table of Contents

Other manuals for Blaupunkt Melbourne SD27

Related product manuals