50
DSC programming
DSC (Direct Software Control) allows you
to customise certain programmable, basic
settings to suit your personal needs and
preferences and then store them.
The basic settings for this audio equipment
were made at the factory.
In the following you can find an overview of
these settings, so that you can always reset
to these if desired.
If you wish to alter any of the programming,
• press SRC to choose the desired oper-
ating mode (e.g. radio, if you wish to
change the language with PTY LANG).
• press DSC.
Use the rocker switch to select and adjust
the functions described in the following. The
display will show you the adjusted condition.
/ Select function
<< >> Adjust/recall value
AM ON / OFF
(Melbourne RCM 148,
Miami DJ)
You can deactivate one or
both AM bands (MW/LW) in
order to reduce the number
of bands for selection with
BND.
selectable:
AM ON – all bands
MW OFF – LW, FM
LW OFF – MW, FM
AM OFF – FM
MIX For changer operation only.
MIX CDC -
CD selection at random.
All titles of this disc will be
chosen in random order as
well.
The next disc is again se-
lected at random.
MIX OFF -
The MIX function is
switched off.
CDC DISP For changer operation only.
To select the display mode
NAME, TIME, or NUMBER.
See changer operation - Se-
lecting the display mode).
CDC NAME Only available for CD
changer playback (optional).
Use this function to name
your CDs. (See “Entering
CD names”).
RM
ON / OFF
(Radio Monitor)
For tape operation only.
Allows you to listen to the
radio during fast winding of
the tape.
RM ON – Radio playback
activated
RM OFF – Function deacti-
vated
BLS (Blank Skip – to skip unre-
corded tape portions auto-
matically)
For tape operation only.
BLS ON – Automatic fast
tape forwarding if the sys-
tem senses an unrecorded
tape portion continuing for
more than 10 seconds.
BLS OFF – The function is
deactivated.
HH/Melb/Miami gb® 15.05.2002, 13:46 Uhr50
To Next Page
Loading...
