29
ENGLISH
DEUTSCH
FRANÇAIS
ITALIANO
NEDERLANDS
SVENSKA
ESPAÑOL
PORTUGUÊS
3
For instantly muting the volume.
By pressing the
button the volume
can be muted immediately. “MUTE”
will appear in the display.
The function is cancelled by pressing
button or VOL+.
When pressing VOL-, the
(mute)
volume will be adopted.
To programme the mute volume level,
proceed as follows:
• Adjust the desired volume.
• Press
for 1 second until you
hear a beep.
Now this volume level is stored as your
mute volume.
Extra function
Memory button in the DSC menu.
Switching on/off via the ignition:
If the equipment has been connected
correspondingly, the set can also be
turned on and off with the vehicle igni-
tion.
After the ignition has been switched
off, a double beep tone will remind you
that you should remove the KeyCard
before leaving your vehicle.
Switching on when the ignition is
switched off:
To keep on operating the set when the
ignition is switched off (KeyCard is in-
serted), proceed as follows:
Press ON after you hear the double
beep tone.
The unit will turn on.
To prevent the battery from going
dead, the system will turn off automati-
cally after it has played for one hour.
2 VOL+ / VOL-
To alter the volume.
Each time the set is switched on, it will
play with the pre-adjusted volume
(VOL FIX).
You may also change the VOL FIX set-
ting (see chapter “DSC programming”).
Quick reference
1 Switching on with the buttons:
Press one of the buttons illustrated
here after you have inserted the Key-
Card.
The unit will play at the pre-adjusted
volume.
Switch off with the ON button.
Switching on/off with the KeyCard:
When turned on, the set can be
switched off and back on by removing
and re-inserting the KeyCard.
Note:
Be sure to read the information in the
section on “KeyCard theft protection
system”.
HH/Melb/Miami gb® 15.05.2002, 13:46 Uhr29
To Next Page
Loading...
