43
ENGLISH
DEUTSCH
FRANÇAIS
ITALIANO
NEDERLANDS
SVENSKA
ESPAÑOL
PORTUGUÊS
Adjusting the Volume for Traffic
Announcements
➮ Press the MENU button, 8.
➮ Press the or button, :, until
“TA VOLUME” appears in the dis-
play.
➮ Adjust the volume with the
buttons, :.
➮ When the setting process is com-
plete, press the MENU button, 8,
or OK, ;.
Note:
● During a traffic announcement you
can adjust the volume for the dura-
tion of the announcement using the
volume control, 2.
Note:
● You can adjust the tone and the
volume distribution for traffic an-
nouncements. For more informa-
tion, read the section on “Tone and
volume distribution”.
Traffic Information
This device is equipped with an RDS
EON receiver. EON means Enhanced
Other Network.
Whenever a traffic announcement (TA)
is made, the radio switches automati-
cally from a station that does not broad-
cast traffic information to one in the
chain of stations that does.
After the traffic announcement, the de-
vice returns to the station that was pre-
viously tuned in.
Switching Traffic Information
Priority On and Off
➮ Press the TRAF button, ?.
Traffic announcement priority is activat-
ed if the traffic jam symbol is illuminat-
ed.
Note:
You will hear a warning tone
● if you leave the reception area of a
traffic radio station to which you are
listening.
● if, when you are listening to a cas-
sette, you leave the reception area
of the selected traffic radio station,
and the automatic search which
then follows fails to find a new traf-
fic radio station.
● if you change from a traffic radio
station to a station with no traffic
information.
Either switch off the traffic information
priority, or change over to a station with
traffic information.
TRAFFIC INFORMATION
To Next Page
Loading...
Need help?
General
