Lübeck RCC 45
24
TA VOL Use this function to adjust the
traffic announcement and
warning beep volume from
between 1 to 9.
The messages and the alarm
tone will then be output at this
volume.
LED You can adjust the LED ? to
flash for extra anti-theft pro-
tection.
LED +1 - The diode will flash
when the unit is
switched off.
LED 0 - The diode is
deactivated.
LOUD Loudness - When listening at
a low level, the Loudness
function will create a more
natural sound by boosting the
low frequency range.
LOUD +1 - No boost / off
LOUD 0 - Max. boost
To quit the DSC programming mode and
store the adjustment:
• Press DSC.
Overview of the DSC factory
settings
TA VOL : 5
LED : +1
LOUD : +1
Appendix
Specifications
Amplifier
Output power: 4 x 6 watts RMS power
acc. to DIN 45324/3.1
into 4 Ω
4 x 8 watts max. power
acc. to DIN 45324/3.2
FM waveband:
Sensitivity: 1.0 µV at 26 dB signal-to-
noise ratio
Frequency
response: 35 - 15 000 Hz
Tape player:
Frequency
response: 40 - 14 000 Hz
Subject to modifications!
To Next Page
Loading...
Need help?
General
