FIGURE 1 (Normal position) FIGURE 2 (Position
after door reversal)
1 - Upper hinge cover
2 - Screw
3 -
Upper hinge
4 - Door
5 - Lower Door Hinge
6 - Screw
7 - Hole cover
8 - Cabinet
9 - Pin cap
• Insert the lower door hinge in the right side, fix the lower
right hinge
by tightening all the screws.
• Remove the pin
cap (9) from the right side of the upper
frame of the door, and then transfer it to the same location
on the opposite side.
• Put the door on the Lower Door Hinge (5), keep the door
level , and then fix the upper hinge (3) to the body (4) by
the screws
• Put on the upper hinge cover (1).
• Your unit has only one control for
regulating the temperature in the compartment. The
temperature control is located on the upper right hand side of the compartment.
• The first time you turn the unit on, set the temperature control to “6”.
• The range of the temperature control is from position "OFF” to “6”. After 24 to 48 hours,
adjust the temperature control to the setting that best suites your needs. The setting of
“3” should be appropriate for home or office use.
• To turn the appliance off, turn the temperature control to ”OFF”.
NOTE:
Turning the temperature control to “OFF” position stops the cooling cycle but does not shut
of
f t
he power to the unit.
If the unit is unplugged, has lost power, or is turned off, you must wait 3 to 5 minutes
before restarting the unit. If you attempt to restart before this time delay, the unit will not
start.
(D) Reversing the Door Swing of Your Appliance Cont'
OPERATING YOUR UNIT
Setting Temperature Control
8
www.blazegrills.com
To Next Page
Loading...
