BM40/2 JOYSTICK MONOBLOCK DIRECTIONAL CONTROL VALVE / INSTRUCTIONS MANUAL
9
EN
WARNING
• All hydraulic valves must be properly installed into the hydraulic system to prevent personal injury and/or property damage.
Further, the improper servicing of a valve may result in personal injury and/or property damage. Please read and understand
all catalogue and service information before starting, as with all mechanical work the proper tools, knowledge, and safety
equipment are required, always wear safety glasses.
• Make sure all pressure has been relieved in the hydraulic lines before installing or servicing a hydraulic valve.
• Escaping hydraulic uid under pressure can have sufcient force to penetrate skin, causing serious personal injury. Do not
use your hand to check for hydraulic leaks.
• Before installing or servicing a hydraulic component make sure all weight has been removed from the cylinders or motors
before disconnecting hydraulic lines.
• Disconnecting the hydraulic lines while the cylinder or motor is under load may result in the unexpected rapid movement of
machine resulting in serious personal injury.
• Do not exceed the operating specications for pressure, ow or temperature, all hydraulic systems require a means to limit
the maximum pressure. This requires either a pressure relief valve in the system or a pump that has pressure compensation.
• Overpressure may cause sudden and unexpected failure of a component in the hydraulic system resulting in serious personal
injury, always use a gauge when adjusting a relief valve.
To Next Page
Loading...