Inner Sensor Installation
Inner Sensor Installation Steps
1. Remove tire cap 2. Install tire sensor 3. Pump up the tire
4. Put valve cap 5. Test balancing 6. Adjust balance
Each sensor has a unique ID code. Please make
sure sensor installed in corresponding tire.
Left up
①
③
②
④
Installation Diagram：
Note: After sensor installation, please pump up the
tire and open the APP in cellphone (Choose
Auto Pair) at the same time. Then Press
“Search” button to finish sensor bind shortly.
Attention: 1) Above steps should be done by
professional technician;
2) After sensor installation, please
check if there's tire leakage.
Left Down
Right up
Right Down
To Next Page
Loading...