Installation Guide
Twist2Go Roller Blinds
Fitting a Twist2Go Roller Blind
Insert the blind into the recess at an angle and push the
tightener against the wall.
Lift the control end of the blind until level and release
pressure, the blind will hold itself in place.
Make adjustments to the position of the blind so that it is straight and level, before locking it in place.
Top Tip
Make sure that you tighten the wheel as much as you possibly can so that the blind remains secure and does not slip.
We’ve made a handy video version of this section too!
Again, if you prefer to print the instructions or simply to
follow step-by-step, just keep reading.
Left Control
Tightener on the right
Right Control
Tightener on the left
Hold the blind securely in place and turn the
tightening wheel to tighten the blind in place.
Turn the wheel clockwise relative to the roller tube.
For smaller blinds:
Minimum 150cm
For safety reasons, always
ensure that the top of the
blind is installed at least
150cm (1500mm) from the
floor.
To Next Page
Need help?
General