Blitz HydroLift Series - Page 106

HydroLift
Operation
126746 103
1
10.7 Change system grouping
DANGER
Risk of death and injury when using safety stands
◼ Always perform this function under the supervision of a qualified person.
This allows height correction on a single wheel or on a vehicle axle without disintegrating the
group. Press key (1) 3 times to return to the initial state.
Press once:
The lifting unit on which the key is pressed, will be active.
The lifting unit is in single mode.
Press twice:
Both lifting units of the same vehicle axle are active.
They raise and lower together.
Press 3 times:
The initial grouping is restored.