Ⅰ.Safety instruction
Warning:
1. Make sure the power supply coincide with the power transmission and distribution.
And the parameters of the power point should meet the requirements of power line.
2. The enter water pressure should be between 0.2-0.4Mpa (Rate of flow≥4L/min).
If the pressure is below the range, the water maybe not inflow normally; If the
pressure is above the range, it may damage the water inlet value.
3. Never alter the machine in any way, only the manufacturer specified spare parts can
be used for repairs
4. Keep the machine away from gas supply or any other flammable and explosive
objects.
5. Make sure the machine surface isn’t contact with any flammable and explosive
objects and used in a fire safety environment. Also the water boiler should have at
least 50cm distance from any other machine.
6. Don’t do any dismounting which isn’t mention in manuals, and confirm whether
the ground wire has been connected fixed.
7. Don’t touch the water faucets with your hands and be careful not to be scalded.
8. The water boiler should be used indoor. Don’t set it up outdoor or used in humid
environment.
9. Don’t use damaged power line for connecting. Before using the water boiler, please
first replace the damaged spare parts to avoid leakage fault.
10. Before repairmen or maintenance, please first cut off the power and water.
11. Share ground wire with other machine is forbidden, so as to avoid being influenced
by other machines’ leakage fault.
12. Please confirm the silicone tube has connected to the air outlet fixed and unimpeded,
if it is blocked or curved, the steam would not be exhausted and the chamber
pressure would be increased.
13. If the enter water pressure is higher than limit, or the water scale is too much, it may
give rise to overflow problem, Install filter and pressure regulator as required.
14. The water boiler must be installed and maintained by qualified electrician.
15. The water quality should reach the requirement as manual mention. If it isn’t
applicable for drinking, please set up a water filter.
Attention:
1. The silicone tube should be connected to the water outlet fixed to avoid overflow
problem.
2. Please don’t allow children to use the water boiler alone, in case they get scald.
3. Please use applicable municipal water through a water filter/softener.
4. Please avoid direct solar radiation which would highly increase machine
temperature and influence the electronic control circuit, or even damage it. So
please keep the humidity between 10~60%, and the ambient temperature should be
between 5~40℃.
5. The enter water temperature should be above 5℃, not freezing. If it is need to use
To Next Page
Loading...