34 / EN
Fully Automatic Coffee Machine / User Manual
Problem Cause Solution
The appliance does not
work.
The appliance is not connected
to the mains.
Plug in and press the switch.
Check the cable and the plug.
No or delayed response
in several attempts of
pressing a function key
on the panel
Appliance is under electro-
magnetic interference. The
panel is dirty.
Unplug the appliance. Re-
start after a few minutes
Clean the panel with the
cloth provided.
The coffee is not hot
enough.
The cups have not been pre-
heated.
The brewing unit is too cold.
Place your cup on the cup
warmer facing down or rinse
the cup with hot water.
Make sure that the water
in the water tank is not too
cold.
Coffee is not coming out
of the coffee spout.
The empty system function may
have been used previously.
The coffee spout may not have
been cleaned and is blocked by
coffee residues.
Press the hot water button
until water comes out of the
spout.
Clean the coffee spout.
The first cup of coffee is
of poor quality.
The first running of the grinder
does not place a sufficient
quantity of coffee into the
brewing unit.
Throw the coffee away. The
next cups
will be better.
The water tank is re-
moved / the water level is
very low in the water tank
but there is no " " alert.
The area near the water tank
connector could be wet.
Wipe off the water around
the water tank connector.
The internal drip tray is
filled with a lot of water.
The ground coffee is too fine,
which blocks the water from
coming out.
Adjust the coffee fineness to
larger grains for the grinding
process.
7 Troubleshooting
To Next Page
Loading...