Blomberg DWT37200 - SETTING THE WATER SOFTENER

17
USA
8. SETTING THE WATER SOFTENER (DEPENDING ON MODEL)
1.Press the Cycle Select button before you switch the appliance on and keep this button pressed
down.
2.Switch the appliance on using the On/Off button; then release the switch.
3.Hold the Cycle Select button down for 10 seconds until the control indicator on the Start/Pause
button begins to flash.
4.Water hardness can be set to the desired level by pressing the Cycle Select button (compare
the test strip with the degrees of Hardness Table). The appropriate program follows up lights
up.
5.Once you have set the hardness level, press the Start/Pause button to save the value. The
control indicator on the Start/Pause button now lights up permanently.
6.Switch the appliance off again using the On/Off button.
HARDNESS TABLE
Notice :
· If the water hardness level is less than 7 American degree of hardness, you do not need
any special softening salt. In this case the 'salt' control indicator lights up continually
(depending on model).
· If your local hardness level exceeds 47 American degree of hardness, you should consider
getting a water softening device for your dishwasher. If you use stream water or rainwater,
you are advised to install filters.
· If you move do not forget to adjust the water hardness level to suit your new neighborhood.
Turn on the tap and
let the water run for
about a minute.
Remove the test strip
from the packet.
Hold the test strip in
the water for about
a second.
Remove the test
strip from the water
and shake it.
Wait for 1 minute. The test strip shows
you the hardness
level.
1 min.
b
e
1 Minute
1 Second
c
d
f
a
Name of unit
American
PPM
Indicator in the Multi-Function
Display
1
2
3
4
5
6
0-105
106-210
211-320
321-409
0-5
6-11
12-17
18-22
0-6
7-12
13-18
19-23
410-624 23-34
24-36
625-804 35-45
37-47
Definition
German
1 grain of CaCO
3
/
1 gal (US) of water
1 mg of CaCO
3
/
1 L of water
10 mg of CaO/
1 L of water
The display shows the message:
The display shows the message:
The display shows the message:
The display shows the message:
The display shows the message:
The display shows the message: