EasyManua.ls Logo

Blu Grande - Section 4 - Operating Your Fountain; Initial Water Flow Setup

Blu Grande
8 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5
609 E. Pine Street Orlando, FL 32801 • Phone 888-977-8366 • Fax 407-210-6833 • www.bluworldhomelements.com
Fig. 3.1 Fig. 3.2 Fig. 3.3
Section 4 – Operating Your Fountain
Step 4.1 After filling the fountain with water, before turning on your fountain, make sure the Flow Control Valve
(B) is in the closed” position as shown in Fig. 4.1. We advise the closed position so that you can adjust
the water flow as described in step 4.3. If started in the fully open position a surge of water will flow that
may splash. Note: Too much or too little water flow will cause dripping and splashing. Water level must
be maintained at least 2” above the Water Pump (A). If the water level drops below the top of the pump,
damage to the Water Pump (A) may occur.
Fig. 4.1
Fig
4.2

Related product manuals