5.4 Cleaning with Detergents
• When using detergent , always use the
black
detergent nozzle
.
• Pour detergent into the detergent tank.
• The liquid detergent will be mixed with water
automatically, and discharged through the detergent
nozzle at a low pressure.
• Allow detergent to remain on the surface for a short
time before rinsing. Do not allow detergent to dry on
the surface.
• Rinse with clean water under high pressure.
5.5 Shutting Down and Cleaning
Up
1. Skip step 2 if you are not using detergent.
2. After cleaning with detergent, fill the detergent tank
with clean water. Spray water at a low pressure for
one minute, so that all detergent is flushed out of the
system.
3. Stop the engine
4. Turn off the water supply and disconnect the water
supply from the water inlet.
5. Point spray gun in safe direction, push trigger lock,
and squeeze spray gun trigger to relieve retained high
water pressure. Engage the trigger safety lock on the
spray gun
6. Disconnect the garden hose from pump.
7. Disconnect the pressure hose from pump and
pressure gun for storage. For long term storage
instructions, see Instruction Manual.
8. Rewind the pressure hose and attach it to the hose
hook.
9. Disconnect the gun and wand, then insert them into
upper gun holder.
10. Fold the handle and store.
NOTE:
After turning off the machine, wait for 20
minutes to prevent plastic parts from being burned by
muffler, then fold the handle.
IMPORTANT
Working with a detergent ensures quick soaking of
the dirt, and allows the high-pressure water to
penetrate and remove the dirt more effectively.
Always spray detergent on a
dry
surface, do not
presoak the area. Soaking the surface dilutes the
detergent and reduces its cleaning ability.
To Next Page
Loading...