6.4 Adjusting Water Pressure:
1.The water pressure is regulated by the throttle
lever (E).
2.Moving the throttle lever towards the left (Fast
direction) will increase the engine speed thus
increasing the water pressure.
3.Moving the throttle lever towards the right
(Slow direction)will decrease the engine speed
thus decreasing the water pressure.
Notice：When moving the engine throttle to the
minimum (rightmost), the output power of
engine is low. Please don’t operate the machine,
if not, the machine will be flame out stop due to
low engine output power.
6.5 Stopping Engine
1. To stop the engine move the choke lever to the
CLOSE position and then set the engine I/O switch to
O position.
2. Finally move the fuel valve to OFF position.
To Next Page
Loading...