Why is my Blue Star J Series Air Conditioner not cooling or heating air?
Your Blue Star Air Conditioner might not be cooling or heating air because the air filter is dirty, the intakes and outlets are blocked, or the temperature isn't set properly. Check these to ensure proper operation.
What to do if my Blue Star Air Conditioner does not run?
If your Blue Star Air Conditioner does not run, check a few things: ensure the plug is properly plugged in, replace exhausted batteries in the remote controller. Also, if the protector trips or a fuse is blown, wait 3 minutes before restarting, as the protector device may be preventing operation.
What to do if my Blue Star J Series control is ineffective?
If you experience ineffective control with your Blue Star Air Conditioner due to strong interference (like excessive static electricity discharge or power supply voltage abnormality), disconnect the unit from the power supply and reconnect it after 2-3 seconds.
Why does my Blue Star J Series have a peculiar odor?
The peculiar odor from your Blue Star Air Conditioner may originate from external sources like furniture or cigarette smoke. The unit sucks in these odors, which are then blown out with the air.
Why does my Blue Star J Series not operate immediately?
If you change the mode during operation of your Blue Star Air Conditioner, there will be a 3-minute delay.
Why does my Blue Star J Series Air Conditioner make a sound of flowing water?
The sound of flowing water in your Blue Star Air Conditioner is caused by the flow of refrigerant and is not a trouble.
Why does my Blue Star J Series Air Conditioner make a cracking sound?
The cracking sound you hear from your Blue Star Air Conditioner may be generated by the expansion or contraction of the front panel due to temperature changes.
Why does my Blue Star J Series spray mist from the outlet?
Mist appears from the outlet of your Blue Star Air Conditioner when the room air becomes very cold because of the cool air discharged from the indoor unit during COOLING or DRY operation mode.
Why is the compressor indicator (red) constantly lit, and the indoor fan stops on my Blue Star J Series Air Conditioner?
When the compressor indicator (red) lights on constantly, and the indoor fan stops on your Blue Star Air Conditioner, the unit is shifting from heating mode to defrost. The indicator will turn off within ten minutes, and the unit will return to heating mode.
General| Refrigerant | R32 |
|---|---|
| Compressor | Rotary |
| Condenser Coil | Copper |
| Refrigerant Gas | R32 |
| Type | Split |
| Star Rating | 3 Star |
| Energy Rating | 3 Star |
| Power Requirement | 230V, 50Hz |
| Indoor Unit Weight | Varies by model |
| Noise Level (Indoor Unit) | Varies by model |
| Noise Level (Outdoor Unit) | Varies by model |
| Cooling Power Consumption | Varies by model |
| Heating Power Consumption | 1600 W |
| Air Flow (Indoor Unit) | Varies by model |
| Operating Temperature (Cooling) | Varies by model |
To Next Page
