Need help?Do you have a question about the Blue Wave Flow Xtreme NE4522 and is the answer not in the manual?
Prevent children from using the pump as access to the pool and supervise them.
Install pump in a well-drained area with adequate ventilation; use only for intended pool types.
Follow wiring codes, use licensed electricians, and replace damaged cords immediately.
Inspect all pool and spa components frequently due to their finite lifespan.
Locate pump as close to pool as practical and run suction lines as direct as possible.
Install pump on a firm, level base or pad to meet all local and national codes.
Use “Teflon” tape to seal threaded connections on molded plastic components.
Ground and bond motor before connecting to electrical power supply for safety.
Match supply voltage to motor nameplate voltage and ensure adequate wire size.
Perform pressure test, ensure components are sealed, and remove trapped air.
Fill strainer housing with water and ensure all valves are open before starting.
Clean strainer basket regularly and inspect strainer cover gasket.
Diagnose and resolve problems like motor not starting, humming, or low flow.
View HP, Voltage, Hertz, Amps, and Flow Rate for different pump models.
Identify and order replacement parts for FX PRO II pump series.
General| Brand | Blue Wave |
|---|---|
| Model | Flow Xtreme NE4522 |
| Category | Water Pump |
| Language | English |
To Next Page
