2
OPERATION INSTRUCTIONS
To Use the Leaf Net
1. Extend the telescopic pole to the desired length.
2. Attach the leaf net to the open end of the telescopic pole.
3. Scoop out leaves and other debris from the pool.
Spring
Latch
IMPORTANT: The following steps on Pages 2 -3 only apply to pool with Summer Waves Skimmer Pump installed.
For pool with other BLUE WAVE Filter Pump System installed (e.g. Model: CP2000-C, RP, RX and Sand Filtration System) or without any filter system,
please follow the instructions on Page 4 "To Vacuum with a 5/8" Garden Hose" of this manual.
2. Attach the vacuum head to the open end of the telescopic pole.1. Extend the telescopic pole to its fullest length.
3. Turn on the Skimmer Pump, water will start to flow to the pool through the
return fitting. Keep the pump running throughout the vacuuming process.
4. Hand tighten the water hose cap of the vacuum head.
6. Attach the 1¼” flexible hose to the vacuum head and tighten the hose clamp.
7. Put the vacuum head under water.
5. Loosely attach the hose clamps over the cuffs on the open ends of the flexible hose.
To Vacuum with BLUE WAVE Skimmer Pump (SFX) Models
To Next Page
Loading...
