4
2. Attach the vacuum head to the open end of the telescopic pole.1. Extend the telescopic pole to its fullest length.
To Vacuum with a 5/8” Garden Hose (not included)
3. Attach the vacuum bag to the vacuum head, tighten the
drawing string and tie a simple shoelace knot. 4. Twist off the water hose cap.
5. Hand tighten a 5/8” garden hose to the vacuum head.
6. Secure the hose into the hose clip. 7. Place the vacuum under water.
8. Turn on the water supply, it will create a venturi action at
the vacuum head to collect debris into the vacuum bag. 9. Slowly push the vacuum head across the pool floor to remove the debris.
10. When done or the bag is full:
A) Slowly move the vacuum head to the side wall of the pool, turn the vacuum head up-side-down, shut off the water and remove the vacuum head from the pool.
B) Remove the vacuum bag and discard all the debris, flip the bag in-side-out and rinse with running water.
11. Repeat the vacuuming process until the pool is thoroughly cleaned.
Hose Clip
5/8” hose
To Next Page
Loading...
