Blueant Q2 - Multiple Calls and Call Waiting

20
Note: Only the primary phone can play music through the Q2 via A2DP.
Multiple Calls (Call Waiting)*
If you receive an incoming call while you are already on a call the Q2 will play a tone to alert
you.
> Hold Vol + for about 1 second to put your current call on hold and answer the incoming call.
> Hold Vol - for about 1 second to end the current call and answer the incoming call.
> Once you have a call on hold, you can switch between calls by holding Vol + for about 1
second.
Note: If one of the calls ends, some phones do not automatically resume the held call. If this
happens, hold Vol+ for about 1 second to release the hold and resume the other call.
Tip: If you are using multipoint, both phones remain connected during calls so you can also
use these controls to switch between calls on both phones.
* To use this feature, your phone and network must support call waiting.