Why doesn’t my BlueBuilt TV3210 Fan blow fast enough?
If your BlueBuilt Fan doesn't blow fast enough, check if the grilles are dirty. If they are, carefully clean them using a vacuum or a soft, dry cloth.
What to do if my BlueBuilt TV3210 is blowing fast and slow?
If your BlueBuilt Fan is blowing both fast and slow, check if it’s in the ‘natural wind’ mode. If it is, press the button to turn off this setting.
Why doesn’t my BlueBuilt Fan remote work?
If your remote for the BlueBuilt Fan isn't working, try replacing the batteries. Also, ensure the fan isn't in stand-by mode by pressing the power button. Make sure you're pointing the light on the side of the remote at the receiver next to the temperature display.
How to stop my BlueBuilt Fan from vibrating?
If your BlueBuilt Fan is vibrating, ensure the fan is balanced by placing it on a flat, horizontal surface.
What to do if my BlueBuilt TV3210 won’t turn on?
If your BlueBuilt Fan won’t start, check the following: * Is the connector plugged into the socket? * Is the ground fault circuit interrupter on? * Is there a power outage in the neighborhood?
Why don’t the buttons on my BlueBuilt Fan work?
If the display on your BlueBuilt Fan shows the ambient temperature, but the control buttons don't work, ensure that the remote is not in its holder on top of the fan. Take it out and use the buttons on top of the fan. Also, check if the fan is in stand-by mode; if so, press the button to turn on the fan.
How to extend the power cord on my BlueBuilt Fan?
If the power cord of your BlueBuilt Fan is very short, check whether the cord is still rolled up in the storage and remove the cord from the storage.
To Next Page
General