OPERATION USING THE MAINS: 230V/50HZ
1. Never use another source of energy at the same time (battery or gas).
2. Verify that the mains voltage corresponds to the operating voltage specified on
the technical data label at the back of the appliance. If the electrical specifications
are correct, plug the safety electrical connector into an earthed wall socket, which
should be wired according to the ruling regulations.
3. Turn the 230V thermostat knob (left) clockwise to the position “max”. After about
one hour, the effects of the cooling process become visible; frost on the inside
evaporator.
4. The thermostat enables the temperature of the fridge to be adjusted. After a
cooling period of about 5 hours, the thermostat can be set on a desired position;
this position is influenced by the surrounding temperature and the intensity
of use. Select a suitable position for the thermostat knob but do not put at the
minimum position as the cooling process will stop completely (i.e. no cooling). The
appliance can be switched off by removing the plug from the wall socket.
To Next Page
Loading...
Need help?
General