OPERATION USING A BATTERY (12V)
1. Never use another source of energy at the same time (mains or gas).
2. Prior to use of any battery; verify the voltage of the battery with the voltage
indicated on the technical data label at the back of the appliance.
3. When the appliance is powered by a car battery, only switch the fridge on while
the car is travelling. If the appliance remains switched on when the car’s engine
is not running, then the battery will be discharged and it may be impossible to
restart the engine.
4. When using a battery as a power source, there is no thermostatically temperature
controller (i.e. you cannot increase or decrease the temperature inside the fridge).
The cooling performance of the fridge using a 12V energy source would be as
follows: at 25~32° ambient, the inside temperature of the fridge would be around
18~22° below ambient.
5. Pre-cool the fridge using the mains before starting a journey and try to put only
pre-cooled products inside the fridge.
6. To start up the unit, connect the supplied cable at the back in the 12v socket
and put the corresponding side into the cigar lighter socket of the vehicle. To
disconnect, remove the connector from the cigar lighter socket.
To Next Page
Loading...
Need help?
General