S DS200 PIPE DRAIN CLEANER
General Maintenance
Note
SERVICING SHOULD ONLY BE DONE BY A QUALIFIED TECHNICIAN.
DON’T FORGET TO UNPLUG POWER TO UNIT PRIOR TO SERVICE!
Ø Inspect electrical cords and electrical connections.
Ø Keep machine clean and free of debris.
Ø Flush cables with water after each use. Occasionally lubricate cables and couplings.
Ø Check for misalignment, binding and breakage of all moving parts. If damaged, repair tool before use.
Ø Check the cutters for sharpness or damage.
Ø Clean clutch teeth with wire brush. Check the attrition on the 3-jaw clutch. If the points are worn, replace with
identical piece.
Ø After each use coat all moving parts (including clutch driver) with corrosion resistant oil.
Occasional Maintenance
Ø Check brushes for wear and replace if worn.
Ø Grease rocker arms and main bearings every 3-6 months.
Ø Grease main bearings thru grease fitting inside clutch handle slot.
Ø After a lot of use, clutch jaws may need to be replaced.
o Remove the screws that hold the front guard to the housing. Remove screws that hold the nosepiece on.
o Slide out clutch driver and replace jaws.
o Put nosepiece assembly and guards back on.
§ WARNING: DO NOT operate machine with guards removed.
Ø After a lot of use, the V-Belt may need to be tightened.
o Remove V-Belt Guard
o Loosen locknut, turn bolt until V-Belt tightens. Tighten lock nut back up. Replace guard.
To Next Page
Loading...