Bluerock Tools TYP-28A

Questions and Answers

G
gina98Jul 27, 2025
Why is my Bluerock Tools Drill motor not turning on?
- M
  Mark StephensJul 27, 2025
  If the motor of your Bluerock Tools Drill isn't turning on, several factors could be at play. First, examine the external power source, including the extension cord and breaker. Next, check for any loose internal wires and secure them if needed. Also, inspect the motor brushes for defects and replace them if necessary. Finally, ensure the motor's on/off switch is working correctly and replace it if it's not.
S
Stephanie AdamsAug 4, 2025
What to do if Bluerock Tools Drill magnetic does not hold to work area?
- A
  Ashley PruittAug 4, 2025
  If the magnetic base of your Bluerock Tools Drill isn't holding, ensure that you're using a minimum of 3/8” (10mm) of continuous ferrous steel for magnetic adhesion. Note that these drills do not work on sheet metal! Also, make sure the entire magnet base is on the work surface and that the voltage at the machine is adequate. Finally, clear away any debris or excess material between the work area and the magnetic base.
S
Steven PottsAug 11, 2025
Why is there excessive sparking when my Bluerock Tools Drill motor is running?
- H
  howarddonnaAug 11, 2025
  Excessive sparking in your Bluerock Tools Drill motor could be due to debris inside the motor or worn carbon brushes. Check the brushes for unusual wear and replace them if needed. If necessary, clean out the internal motor armature. Another potential cause is a rough edge on the armature; inspect it and replace it if necessary.
J
Jason WilliamsAug 18, 2025
What to do if Bluerock Tools Drill hole is not cutting?
- A
  Adam LopezAug 18, 2025
  If your Bluerock Tools Drill isn't cutting a hole, the cutter may be dull, requiring sharpening or replacement. Alternatively, the work area material might not be suitable for the cutter type. High carbon steels need special cutting bits, such as those with a tungsten carbide tip.