Ø DO allow machine to reach operating speed before starting a hole.
Ø DO unplug machine while changing or adjusting cutting bits so as not to accidentally turn
machine on.
Ø DO remove adjusting keys or hex wrenches prior to turning the machine on.
Ø DO use cutting paste (instead of cutting oil) when using this drill in an inverted position to
prevent oils from entering the electrical system and for ease of cutting.
Ø DO tie a loop in any extension cord connections to prevent cords coming apart and a loss of
power.
Ø DO guard against electric shock by preventing body contact with grounded surfaces such as
pipes, radiators, ranges, refrigerators, etc.
Ø DO be mindful that power tools can expose an operator to vibrations transmitted trough
contact with the machine. Prolonged exposure can lead to medical issues which should be
discussed with a medical professional.
Ø DO tie in a drip loop in the power cord to prevent cutting fluid from running into the power
receptacle.
Ø DO use a dust extraction system for cutting materials that create dust such as cast iron. The
operator should also wear a protective respiratory device.
Ø DO NOT make adjustments to machine while the machine is running.
Ø DO NOT switch off the machine when it is under load, except in an emergency.
Ø DO NOT remove or modify grounding plug. Only to be used on a properly grounded circuit.
Ø DO NOT leave the machine running when not in use.
Ø DO NOT hold the work piece by hand or using body. Always mechanically clamp or secure
work piece.
Ø DO NOT allow coolant oil to enter the machine’s ventilation system.
Ø DO NOT operate machine outside of machine specifications.
Ø DO NOT touch moving parts while the machine is running as death or dismemberment could
occur.
Ø DO NOT allow children or untrained personal to operate machine.
Ø DO NOT use this machine in the rain or a wet environment. If using outdoors, make sure the
adhering surface is clean and dry.
Ø DO NOT operate in the presence of explosive materials as power tools create sparks which
may ignite dust or fumes.
Ø DO NOT drill into an area that may contain a live electrical wire/circuit.
Ø DO NOT operate this machine on the same work surface where welding is being performed.
This could result in severe damage to the machine or personal injury to the user.
Ø DO NOT use this machine without the safety chain or safety strap.
To Next Page
Loading...