01
Thank you for purchasing a BlueSpot product, you can find further information
on our range at www.BlueSpot.uk.com. Please ensure that you are using the
product correctly and that all guidance and cautions are followed in accordance
with the instructions. Please retain these instructions for future reference.
General Information
Please make sure that you read these instructions carefully in order to avoid injury when
using the bearing race and seal driver kit. Follow all health and safety rules and regulations.
If in doubt and available please contact a more knowledgeable source.
DO NOT use if damaged.
• Maintain tool in good and clean condition for best and safest performance.
• Keep the work area clean, uncluttered and ensure there is adequate lighting.
• Maintain correct balance and footing. Ensure the floor is not slippery and wear
non-slip shoes.
• Keep children and unauthorised persons away from the work area.
• If any of the parts within the bearing race and seal driver kit are damaged do not use.
• ALWAYS ensure you have read the instructions fully and feel confident in how to use
the tool before beginning.
• ALWAYS dress appropriately – clothing should be close fitted and long hair tied back.
Jewellery should be removed.
• ALWAYS wear the correct eye protection when operating.
• ALWAYS strike the driver directly on the centre of the head.
• NEVER hit the tool at an angle or off centre. This can be dangerous and cause damage
to property or injury.
• NEVER strike the side of the driver body.
• ALWAYS ensure you are aware of the limitations of the driver you are using. If you do
not know the limitations check with the driver manufacturer before using and
familiarise yourself.
• ALWAYS check for damaged or worn parts before beginning. If damage is found,
replace before beginning. Damaged parts may be dangerous and could cause injury.
• ALWAYS check the driver before use to check for any damage. If damage is found,
replace before beginning. Damaged parts may be dangerous and could cause injury.
• NEVER use any parts of the bearing race and seal driver kit to perform a task that they
Safe use
were not designed for. Do not overload or misuse the tool.
• NEVER operate the tool if you are under the influence of drugs or alcohol as this
is dangerous.
• When you have completed the task intended always ensure the kit is stored away in its
original box and that is out of reach of children.
To Next Page
Loading...
