BlueSpot 07951 - User Manual

Questions and Answers

H
Harold JensenJul 28, 2025
Why is my BlueSpot 07951 air hammer running slowly?
- W
  whensonJul 28, 2025
  The slow operation of your BlueSpot Tools air hammer can stem from several causes. There might be leaks in the air hose – check the connection to the air hammer and secure it with PTFE tape. Low air pressure is another potential issue; inspect the regulator, adjust the compressor to 90 PSI / 6.2 bar, and verify the hose size and length. Dirt or gum accumulation inside the air hammer could also be the culprit; try flushing it with air line oil or gum solvent. Insufficient oil or water in the airline may also cause this problem. Make sure you follow the daily maintenance instructions to lubricate the air hammer with oil and drain the air hammer, running the tool until it is clear of water, then oil the tool.
L
Lori JohnsonAug 5, 2025
What to do if my BlueSpot Tools air hammer is not operating?
- A
  Alicia WilliamsAug 6, 2025
  If your BlueSpot Tools air hammer isn't working, several factors could be responsible. Check for leaks in the air hose connection and secure with PTFE tape. Ensure the air pressure is correct by checking the regulator and adjusting the compressor to 90 PSI / 6.2 bar, and verify the hose size and length. The tool may also not be operating correctly due to dirt or gum in the air hammer, which can be resolved by flushing it through with air line oil or gum solvent. Make sure you follow the daily maintenance instructions to lubricate the air hammer with oil and drain the air hammer, running the tool until it is clear of water, then oil the tool.
N
Nicholas MaddoxAug 12, 2025
What to do if BlueSpot 07951 air hammer will not shut off?
- S
  Samantha MillerAug 13, 2025
  If your BlueSpot Tools air hammer won't shut off, this could be due to damage to the O-rings or the O-ring not being fitted correctly. Replace the O-ring. If you're not sure how to do this, get the tool repaired by a professional.
L
Lisa HoltAug 19, 2025
Why does my BlueSpot 07951 Tools air hammer run erratically?
- A
  Alexander HaleAug 19, 2025
  An erratic running BlueSpot Tools air hammer may be caused by a loose cylinder. Tighten the cylinder, and if you are unsure about doing this, get it repaired by a professional.