Bluestream BS001CR - Alarm Setting Procedures; Setting Alarm 1 (Buzzer;Radio)

NOTE: Some buttons have multiple functions based on if the function requires a
“Press” (Press & Immediately Release the button) command or a “Press & Hold”
(Press & Hold the button for 1-2 seconds) command.
SETTING THE ALARM
CAUTION: Before setting the Alarm make sure the correct TIME is shown on the LED
Display.
NOTE: Before setting the TIME make sure all of the non-clock functions (BLUETOOTH, FM,
AM) are turned OFF. If any of the non-clock functions are playing, turn the function OFF by
simply pressing & holding the FUNCTION button (1).
1. Press & hold the VOLUME DOWN / ALARM-1 button (3) until the time flashes on the
LED display and the ALARM-1 BUZZER Indicator Light (B) flashes. Once the time is
flashing you can
release the VOLUME DOWN / ALARM-1 button (3).
2. Press the PREV / HOUR button (6) repeatedly until the correct HOUR is shown on the
LED display.
• NOTE: The “AM” Indicator Light (A) will turn ON when the hour is set to AM.
For PM hours the “AM” Indicator Light (A) will turn OFF.
3. Press the NEXT / MINUTE button (7) repeatedly until the correct MINUTE is shown on
the LED display.
4. After setting the HOURS & MINUTES press the VOLUME DOWN / ALARM-1 button (3)
to confirm the ALARM-1 time.
5. The cl
ock will automatically set the Alarm-1 for BUZZER and the ALARM-1 BUZZER
Indicator Light (B) will turn ON.
6. To choose to wake to RADIO simply press the VOLUME DOWN / ALARM-1 button (3)
until the ALARM-1 RADIO Indicator Light (C) turns ON.
7. To turn the ALARM OFF press the VOLUME DOWN / ALARM-1 button (3) until both the
ALARM-1 Indicator Lights (B & C) turn OFF.
12:34
B
C F
E
A
EXPLANATION OF DISPLAY LIGHTS
LETTER DESCRIPTION
A
B
C
D
E
“AM” INDICATOR LIGHT
ALARM-1 BUZZER INDICATOR LIGHT
ALARM-1 RADIO INDICATOR LIGHT
ALARM-2 BUZZER INDICATOR LIGHT
ALARM-2 RADIO INDICATOR LIGHT
F
D
BLUETOOTH INDICATOR LIGHT
5