BlueWear 004508 - Symbols and Standards; CE Symbol Explanation; Conformity to Regulations; Technical Data Overview

EN
24
impulse noise is considered to occur if the
noise level has a peak value with an
interval longer than 1 second. Impulse
noise can also occur in environments with
continuous noise, and dierent users have
dierent tolerances to impulse noise.
There is therefore no generally accepted
way of determining whether ear
protection provides adequate protection
from impulse noise.
• Ear protection should always be used in
noisy conditions to provide protection
from hearing impairment.
• Ear protection should be checked at
regular intervals for damage and wear.
WARNING!
• There are small and large ear protectors.
The earmus tted on this helmet
comply with EN 352-3 and are of the
small medium or large type. Medium
sized earmus will suit most users.
Small or large models are intended for
users who cannot use earmus of the
medium model.
• Some chemicals can have a negative
eect on the product. Additional
information can be obtained from the
manufacturer.
• Ear protection, and in particular the
seals on the cups, can deteriorate as a
result of wear and should therefore be
regularly checked for cracks, noise
admission and other damage.
• Hygiene covers on the seals can aect
the noise damping capacity.
• This mesh visor is marked with the
designation S and must not be used
when there is a risk of being hit by hard
and sharp objects.
• The mesh visor is intended as protection
from injuries caused by splinters and
objects with moderate impact energy –
heavy objects with high impact energy
can rupture it. The visor has no ltering
eect and does not provide protection
from hot objects, splashed molten metal
or electric shock.
• Always fold down the visor when using
the helmet.
• The visor does not provide protection
from splashing, hot objects, electricity or
infrared/UV radiation.
• Do not use the visor in environments
where there is a risk of being hit by
hard, sharp objects.
• Wooden splinters and resin can damage
the visor and reduce visibility.
SYMBOLS
Conforms with the
requirements in the relevant
EU directives.
REGULATIONS AND STANDARDS
• (EU) 2016/425 – Regulation for personal
protective equipment (PPE).
• EN 352-3:2003 – Ear protection.
• EN 397:2012+A1 – Safety helmets.
• EN 1731:2006 – Visors.
TECHNICAL DATA
This product is CE marked to demonstrate
compliance with the EU directive for personal
protective equipment (EU) 2016/425.
Notied Body: 2754
ALIENOR CERTIFICATION ZA DU SANITAL
21 RUE ALBERT EINSTEIN 86100 CHATELLERAULT
France
SAFETY HELMET
Marking 004653-57 S CE
Size (head size) 52-66 cm