16 | P a g e
7. Software revision level
8. Cell type (F-3,F-9,C-9,F-15,C-15,T-15)
BLH20: F-3 BLH30: F-9 BLH40: F-15
9. Salt Calibration (E000)
10. End of the loop (-EE)
Spring Start-up
When reopening the pool after long term, check all water chemistry
before power on the BLH.
Maintenance
When checking other water chemistry levels, always monitor the salinity
level of the swimming pool.
After the system runs for a period of time, it will eventually need to clean
the cells due to the scaling of natural minerals.
You will be notified by opening "CHECK CELL" Light. When lit, cleaning
the cell with a cleaning stand is better.
Important information: The frequency of cleaning depends on your
water chemistry and water saturation index.
For most people, only need to clean a few times per season. Faster
mineral accumulation must be long-term high saturation index,chemical
imbalance may lead to rapid fouling. Consult Swimming pool
professionals.
To Next Page
Loading...