17 | P a g e
How to clean the cell?
Important information: If there is severe mineral accumulation, more
than one cleaning may be required to dissolve the remaining solids.
After cleaning, carefully inspect the cell plate with bright light. If you see
any remaining scale, debris or physical blocked in the salt cell, please
repeat the cleaning process as needed. If it is "check cell"come back
soon after cleaning,
1) Confirm that the salinity is within the range
2) Ensure that the cell is fully filled with water
3) Verify the cell type setting of the system
Before removing the cell for cleaning or replacement:
1) Turn off all power sources of all swimming pool equipment and close
the water supply line valve (if applicable).
2) Unplug the cell cable connecting to the control box.
3) Loosen the threaded ring around the joint at the junction of the pool
and the pipes.
To clean the cell with mineral deposits:
1) Cleaning stand and adjust the direction of the cell vertically. Place on
the ground and stabilize to keep it upright.
2) In a separate bucket, mix one part of muriatic acid with four parts of
water. Pour this acid solution directly to cell. Make sure that the
cleaning water completely covers the components inside the cell.
3) Wait for the foaming to stop. Let the solution soak for no more than
fifteen minutes.
4) Properly dispose of the acid solution, and use a hose to wash away
the remaining debris from the pool.
To Next Page
Loading...